After you have raised the vehicle off of the ground, you then loosen the rest of the lug nuts and begin to take the tire off. Place the lug nuts in a safe location where they wont get lost. Then take the flat tire off and put it in your trunk, while replacing it with the spare. If you are unsure which way the spare goes on, make sure the valve (small tube sticking out the tire where air is placed) is facing out. The final steps of fixing a flat tire are tightening the lug nuts by turning them clockwise until they are nice and snug.
The first thing the person tying the shoe (or one) should do is to make sure that the shoe fits snug. Do this by taking the left lace in the left hand and the right lace in the right and pull them until the shoe fits comfortably. Be sure not to pull too tightly or else the shoe will later become uncomfortable. The next step would be to cross the laces. With both the right and the left laces still in hand take them and pull them across from each other forming the letter X.
Now that we have all of our tools lets move on to our first step to changing a tire. Now it is time to take your first step in changing you tire on you vehicle. Step one is to jack up the front or back end of the vehicle depending on the tire that needs to be changed. To jack up the vehicle with the portable jack, you will need to place the jack under the sturdy part of you frame next to the tire. Keep in mind the bottom of the jack needs to be semi level with the ground
You’ll end up with two halves. On the front half will be the cornea. The cornea is made of pretty tough stuff—it helps protect your eye. It also helps you see by bending the light that comes into your eye. Once you have removed the cornea, place it on the board (or cutting surface) and cut it with your scalpel or razor.
Release all the tension on the strings by loosening them at the tuning keys. This should be done on the top of the guitar where the neck is lying on the foam. Cut each string with wire cutters. Cutting the strings at the middle of the fret board makes it easier to handle the strings. This way you don't have long strings flopping around.
Be sure to clean the bushings and track links before using the proper tooling for separating the track to insure the tool works properly. When using a track press, make sure suitable lifting equipment is used to support the tooling. Also never remove the upper rigid guard or lower flexible guard on the track press while under pressure. Make sure that the pins are pressed out evenly also. Use a suitable lifting device to support the track in order to lower it to the ground for unwrapping.
And this will be the starting Point of each trial. Before you start your lab, Practice releasing the boxcar. Make sure the cart doesn’t fall backwards off the plank. So make sure that you are releasing the cart the same ways you released it the first time, is really IMPORTANT! Then use the Meter stick to measure the center distance of the back wheels to the front wheels.
Separate the jumper cables making sure the clamps do not touch; it could cause a short circuit. Before clamping one of the red cables onto the positive terminal you may need to remove a plastic cover. After you have removed it or it was already removed, you can now attach the clamp to the positive terminal of the dead battery making
For this step we will need the following items, a toothbrush, cotton swabs, paint brush, and a rag. Any of these items new or used will be fine. Dust off the outside of the rifle with a brush. A barber or half-inch paintbrush is ideal for this. Use a toothbrush or cotton swabs for the areas around the trigger and front sight-posts.
When your dominant wrist is curled as far as it can go inward, start bringing your wrist back out and your arm back down to its starting position. Now you have to learn how to pass. To pass to another person, lower your dominant hand to the center of the shaft. Then bring the shaft of your stick back by twisting your shoulders toward your dominant side. Then keep your wrist next to your ear, in a quick and fast motion, flick the wrist of your top hand while pulling your top hand towards you.