Physics Mission Impossible

441 Words2 Pages
Darrell Dadzie Ms ortlani 3/31/15 physics Mission impossible My project in physic is a white peg board with, holes in it which the height of the board is 4 by 8. We are constructing a chain reaction, so one thing has to hit another to form some type of reaction. We used cardboard, as a ramp for the board. Starting from the front all the way to the back. We used a marble so that it could go on its little adventure through different obstacles on the ramp. My goal for this project was to use abundant amount of supplies. Some of the supplies we needed for this project were a pin mill, A little toy football, cardboard to make the ramp, pop balloon, gold pins, slinky, put a match on fire, and blow a bubble, jingle bells, make a target, kick a football in a field goal . The first thing I did was put a cone on the board 65 degrees, and build a ramp using cardboard and Styrofoam. I started off using the cone and dropped the marble, as it went down the slinky, first creating a decline to get a better speed, it hit several objects. I have hooked the slinky on the cone and also on the Styrofoam. I cut a rubber band in half ,for it to hold the slinky and Styrofoam in place. I wrapped one end of the rubber band through the holes of the peg board, then the other end around the Styrofoam. So the marble travels from the slinky on to the ramp, then next I set up a fishing line wire filled with three jingle bells. I wrapped the fishing line wire around creating a circle filled with the jingle bells. I then cut a piece of rubber band and tied it on the fishing line wire through the board. Making a nice ring tone, once the marble hits

More about Physics Mission Impossible

Open Document