Then convert the address to decimal form. By controlling which IP addresses assigned to the individual computer, you must make sure you assign it one of the IP addresses your provider gave you; assign it the netmask your provider gave you; and assign it a gateway, which is the IP address of your router When setting up a router, you: assign it the IP address, in the range, your provider gave you; assign it the netmask your provider gave you; tell it the IP address of your ISP's
| Question 4 | What is the name of the computer you are working from? SEA-SVR2 | Question 5 | What IP addressing settings are currently configured?10.10.0.12 | Question 6 | Is the computer currently configured for DHCP? How can you tell? Yes, DHCP enabled and it received an ip address of 10.10.0.20 | Question 7 | What is the IP address of the DHCP server from which W2K8yy has obtained its IP address? DHCP Server 10.10.0.11 | Question 8 | If the answer to #7 was not the IP address of the SEA-SVR1 computer, why might this have happened?
What is one of the earliest mechanisms designed to provide Web servers with application-hosting capabilities? A) UDDI B) ISAPI C) CGI D) SSI Feedback: The Common Gateway Interface (CGI) is one of the earliest mechanisms designed to provide Web servers with application-hosting capabilities. CGI is essentially a protocol that enables a Web server to run an application specified in a client request and pass the request to that application for processing. The Web server then receives the output from the application and packages it as a reply to the client in the form of a Web page. Table for Individual Question FeedbackPoints Earned:1.0/1.0Correct Answer(s):C 3.
IP Address Class A, Class B, and Class C IP Address classes were the original organizational structure for IP addresses. The specific address class would determine the maximum potential size for a computer network. The address class would define which of the specific bits of the address would be used to identify the network and network identification, the bits to identify the host computer and host ID, and total number of host subnets permitted per network. Five total classes of IP addresses were defined, class A through E. Although the IP class term will commonly be used to describe the difference between one network and another, the practical use of addressing is not commonly used any more. It has been replaced with classless addressing where a netmask can be assigned to any IP address range.
Which of the following is a Windows command-line utility for seeing NetBIOS shares on a network? * c. Net view 29. To view eDirectory information on a NetWare 5.1 server, which of the following tools should you use? * d. Novell Client 30. The Nbtstat command is used to enumerate *nix systems.
NT1210 Research Paper From what I gathered about “Layer 2 switches” is that the Layer 2 switches use a MAC address from a host NIC card. This makes it to decide where to “forward frames”. Also Layer 2 is a hardware-based control. It uses “application-specific integrated circuits”, which provides “wire speed, high speed, low latency”. OIS layer 7 packets are called “layer 4-7 switches” these are like content switches, content service switches and web switches or application switches… Content switches are normally used for “load balancing” among server groups like on TCP/IP.
Suppose the university has the 128.100.xxx.xxx address range on the Internet. How would you assign the IP addresses to the various subnets? How would you control the process by which IP addresses are assigned to individual computers? You will have to make some assumptions to answer both questions, so be sure to state your assumptions. Answer After I study the case, I will control the users IP addresses validating them by a Domain Controller.
Chapters 7-9 70-643 Chapter 7 Matching A. Application hosting technology that launches a separate for each request is Common Gateway Interface (CGI.) B. The Internet Server Application Programing Interface(ISAPI) provides the interface between IIS and ASP.NET in IIS7’s Classic mode. C. The first Web technology to enable servers to process code in HTML files is Server Side Includes (SSI).
Refer to the exhibit. A router learns a route to the 192.168.6.0 network, as shown in the output of the show ip rip database command. However, upon running the show ip route command, the network administrator sees that the router has installed a different route to the 192.168.6.0 network learned via EIGRP. What could be the reason for the missing RIP route? Compared to RIP, EIGRP has a lower administrative distance.
2. a) What technology components (cover the categories of software, hardware and networks) do we need at FastFit to interact with our customers on the web? (use a table) b) At what location within FastFit would you place these technology components and why? (use a table) A) Hardware | Software | Networks | Personal Computers | * World Wide Web * VOIP software | Access to the Internet | Servers | Electronic Mail | Internet | Bar Code | Database with reliable information | Internet | Modem | Security Firewall to control outsiders’ access | Internet | B) Location to place Technology Components | Why? | Headquarters | All the operations must be controlled from headquarters, so the right placement of these components is HQ. The store