Next, fill the bucket half way with water, then add a cup of car wash shampoo. Stir the bucket with a sponge before rubbing and wiping the car body. You rub and wipe the car with the sponge from the top to bottom of the car but the wheels and rims are the last area because they are the dirtiest parts of the car. Rinse all the soap with the from the water hose or pressure washer then dry the water by wiping with a charmeuse cloth. Then let the water around the car washing area dry also.
Used when doing personal care and disposing waste Uniform - You should have a clean uniform when starting your shift and remove your uniform at the end of your shift and take it home and wash it. 5.8 Gloves and Aprons are classed as high risk items so you should dispose them in a yellow bag. Uniform can go in the laundry for a wash. Question 6 6.1 > Wash hands before and after every activity > Wear a clean uniform > Cut and clean nails > Have a Bath, wash your hair 6.3 1. Palm to palm 2.
Cleaning, decontamination and waste management (IC 03) Unit 1 Understand how to maintain a clean environment to prevent the spread of infection 1.1 State the general principles for environmental cleaning • All cleaning equipment should be clean and maintained properly •Work surfaces and floors should be clean and intact, clear of clutter, dust free and good quality •GDP and water should be used (following the manufacturer’s instructions) Disinfectant should only be used to decontaminate spills of bodily fluids or for cleaning of an area after an outbreak of an infection •All cleaning equipment should be colour coded for different areas, as per National colour coding guide •Mop heads and
Cure: Remove the water and dry the floor as quickly as possible. Elevate the temperature, dehumidify and increase air flow using fans. In basement houses, dry from below. In crawl space homes, use exhaust fans. If the flooding was of a long duration on a surfacefinished floor, rough sanding to remove the finish will accelerate drying.
| | | | | | |Washing a contaminated scope. (Gastro |Once a contaminated scope has been used and then come through into the dirty side off scope | |scope/Colon scope) |wash, I first fill my sinks with water and put one squirt off disinfectant which is Thermoton| | |into the dirty side off the sinks. | | |I then put on my PPE which includes | | |Red apron
5.8 Describe the correct procedure for disposal of used PPE Appropriate disposal of single-use items of PPE should be done immediately when you have been dealing with clinical or hazardous waste. You should ensure that reusable items of PPE are prepared for the next time they are to be used (send to the laundry appropriately labelled or disinfect them carefully). Always dispose of PPE in accordance with your organisation’s policies, procedures and guidelines. 6.1 Describe the key principles of good personal hygiene Hygiene is important as bacteria and micro-organisms can be easily transferred by hands, clothing and equipment. Ways of adhering to good standards of hygiene will be documented in your organisation’s standard operating procedures.
Use tape to tape lift hairs, fibres, paints, particulates and prints. Use a pipette to collect wet, pooled samples. Brushing can be used for particulates or large amount of debris and digging can be used to recover buried items or seepage. You can hand pick larger (macroscopic) items. Package and storage of evidence Blood in liquid pools should be picked up on a gauze pad or clean sterile cotton cloth and allowed to dry at room temperature.
7,8,Any spillages,i would clean thoroughly and as quickly as possible using the correct materials and equipment for that particular spillage.I would effectively wash my hands using an effective antibacterial soap,after collecting and disposing of body
Tyre arrives in the Retreading Center, it is cleaned carefully with water so, that dirt, dust and mud should all be removed successfully. b. Tyre is left for some time so that it may waterless or a drying device can be used for this purpose. c. Initial examination is carried out to verify that casing is acceptable for retreading process or not. It is systematically examine inside and outside and marked with yellow colored chalk. d. Buffing: - The principal objective of buffing is to prepare the worn out tread surface of tyre to accept a retread.
First, we’re going to prepare our work area by putting down newspaper to keep everything clean and protected. 2. Next, clean off your shoes with a rag making sure there’s no dirt or debris. 3. Then, dip your soft rag into the show polish, and begin applying to shoe in circular motion (Making sure to get in all the cracks) 4.