Continuity Tester - is an item of electrical test equipment used to determine if an electrical path can be established between two points; that is if an electrical circuit can be made. 13. Category 5e/6 Cable - is a twisted pair cable for carrying signals/ is a standardized cable for Gigabit Ethernet and other network physical layers that is backward compatible with the
The battery’s positive lead pushes current away from that lead, and c. The circuit creates a direct current. 2. A PC NIC and a switch port create one electrical circuit to use when sending data. The sender creates a (maximum) 1-volt electrical signal with a frequency of 1000 hertz. Which of the following facts are also true?
4. B. PC and switch D. Router and hub E. wireless access point and switch 5. B. collisions can happen, but the algorithm defines how the computers should notice a collision and how to recover. 6. C. two PCs, with one cabled to a router Ethernet port with a crossover cable and the other PC cabled to another router Ethernet port with a crossover cable.
The network layer then uses its protocol (IP) and translates that www.yahoo.com into an IP address. The network layer is also in charge for determining the best route through the network in order to get to the IP address destination. The data link layer is, unlike the other two which are virtual, a physical address with is permanently encoded to a device through its network card. The data link layer is a unique identifier to each computer in a network. Thus a MAC address is the only address that will always remain the same, transport and data layer address can change depending on the network.
Ethernet or Token Ring IT 242 Nov 15, 2012 Ethernet or Token Ring For the first scenario of this assignment, I believe that Saguaro Federal should use Ethernet because it is safe and more secure. The reason Ethernet is more secure, is that it deals with the MAC layer of the OSI model. The token ring on the other hand would not be the best choice because everything connects within a star topology type of network connected with hubs. This can cause some problems in the future if one of the components requires maintenance or if it malfunctions. In which this can lead to downtime for the business and its users.
The most common method for illustrating the operations of a networking stack is the __________________, which consists of __________________ layers. Open Systems Interconnection (OSI) reference model, seven 5. Protocols that do not guarantee delivery of their data, but do operate with a very low overhead that conserve network bandwidth are called __________________. connectionless protocols 6. The Windows 7 command-line utility that can tell you if the TCP/IP stack of another system on the network is functioning normally is called __________________.
Adding the manufacturing computers will only make this problem worse and result in another problem. Because the ceiling is more than 30 feet high, there’s no easy way to run cables to computers, and providing a secure pathway for cables is next to impossible. Devise a solution to this company’s networking problems. As part of your solution, answer the following questions: ● What changes in equipment are required to bring this company’s network up to date to solve the shared-bandwidth problem? I would replace the hubs with switches to help increase the speeds at which data is transferred within the network.
Place the lower alligator clip and connecting wire on the lab table and hang the upper connecting wire from the ring stand. Finish the circuit with the connecting wires by attaching them to the switch and to the battery. (See Figure 1). 2. Determine the direction that current will flow in the circuit by noting which terminal of the battery is connected to the top of the wire and which terminal is connected to the bottom of the bare copper wire.
But understanding technology has been a real problem due to the fact that technology is always changing and evolving. This leads to more funds being put into training the staff and physicians to learn how to operate these machines effectively. It also doesn’t help that as the technology evolves, it becomes more expensive. Todd C. Linden, MHA, FACHE, President & CEO of Grinnell Regional Medical Center stated that CT scanners which made thicker slices of section of the diagnostic area of the body have been upgraded to produce thinner slices of sections. The prices of these technology advances have increased from a couple of hundred thousands of dollars to multi-million dollar pieces of equipments.
Equipment required for bioelectrical impedance testing can be expensive compared to skin calipers, so this testing may be found mainly at large facilities. Hydrostatic weighing is often referred to as the gold standard for body