Repeat the titration until there are two titres within 0.1cm3 of each other. Record results in a suitable table. Results: Rough Titre: 7.653 First Run: 6.553 Second Run: 6.453 Third Run: 6.553 Calculations: During the titration, iron(II) ions are oxidised to iron(III) ions and manganate(VII) ions are reduced to manganese(II) ions. The equation is as follows: 5Fe2+(aq) + MnO4-(aq) + 8H+(aq) ? 5Fe3+(aq) + Mn2+(aq) + 4H2O(l) The above equation shows that one mole of manganate(VII) ions reacts with 5 moles of iron(II) ions in acid solution.
2 mL of a saturated calcium acetate solution was added to an evaporating dish. 15 mL of ethanol was added to the dish and swirled. The dish was ignited. 8. 3g of NH4Cl and 7g of Sr (OH) 2 * 8H2O were added to a 125 Erlenmeyer flask and swirled vigorously for 5 minutes.
0.00512 * 500 = 2.56 c. 0.00806 * 319.9= 2.56 d. 0.00806 * 319.9 = 2.56 500 mL =0.5 L e. 0.0161 * 500 / 2 =2.56 4. Exercise 4: a. 0.250M; 250 mL 0.25 L (0.25) (0.25) = 0.0625 moles ZnI2 b. Prepare the solution by dissolving 19.95 grams of Zinc Iodide with 250 mL of water. c. Prepare the solution by dissolving 38.90 grams of ZnI2 with 500 mL of water.
Cylinder was rinsed with distilled water. * * 2. 2.0 ppm standard: 2.00 mL of 10.0 ppm phosphate solution was placed in a 25 mL graduated cylinder and diluted to exactly the 10 mL mark with distilled water then poured into a plastic cup labeled 2. Cylinder was rinsed with distilled water. * 3.
Investigating the Chemical Composition of Alka Selzter Problem: How much sodium bicarbonate is in a tablet of Alka Seltzer? Purpose: To discover the amount of sodium bicarbonate, in grams, in a one tablet of Alka Seltzer. Materials: one Alka Seltzer tablet 50 mL of vinegar post-it note Triple beam balance beaker Procedure: 1) Put the post-it on the triple beam balance and zero the balance. 2) Measure the masses of the alka-seltzer tablet, and the beaker + vinegar. Record them.
What mass of ammonium chloride is needed to make 3.0 liters of a 1.5 M ammonium chloride solution? b. What mass of calcium hydroxide is needed to make 1.00 liters of a 1.5 M calcium hydroxide solution? c. How many grams of calcium chloride will be made when 1.0 liter of a 2.0 M calcium hydroxide solution react
In this step, as we watched the chemical reaction with the solids, we noticed a thinning in the substance. Also, the solids became lighter and moved to the top. When stirred, the solution began to turn green and then back to light blue, where copper began in the end of the first step. A combination reaction took place, and the balanced equation is: CuOs+H2SO4aq→CuSO4aq+H2O(I) Following this step, step 5 began, in which we added 300 mg of zinc to the solution. Once the zinc was added slowly to the solution, a gas was released and the solution began to change colors.
6. Zinc Sheet: a rectangular, thin, sheet like metal, gray/silver. 6 5 4 3 2 1 * Solubility of solid iodine; 1. Solid iodine in 1 mL of water is slightly soluble, because the solution turns into a light brown/yellow color. However majority of the solid Iodine was left at the bottom of the test tube; which leads to the conclusion that it’s not reactive on water.
6. How many moles of NaCl are in 250. mL of a 0.200 M solution? 1. 15.8 g of KCl is dissolved in 225 mL of water. Calculate the molarity.
For zinc ion to react, the NaEDTA must also be an ion in the solution which means that the large salt must be dissolved in water. Procedure 1) Weighed out 3.64 of NaEDTA on an electronic beam balance 2) Added this mass of NaEDTA using wide mouth funnel to a 250 mL volumetric flask. 3) Rinsed the funnel with a squirt bottle containing deionized water making sure none of the solid remained in the funnel. 4) Added about 100-200 mL of deionized water to the volumetric flask containing the solid NaEDTA. 5) Swirled the solution until the NaEDTA (s) dissolved entirely.