17. Repeat Steps 12 through 16 above for well #2 and well #3 and record your data under the Trial 1 column in the Data Table 1. 18. Wash the well plate immediately with liquid soap and dry the well plate thoroughly with paper towel and cotton swabs to remove any precipitate from the bottom of
Then the same was done with each of the other substances. Weezie was washed off with water after the baking soda. Next, the tray was washed and dried. Then, using the spatula again a small amount of orange juice, molasses, veggie oil, and vinegar was placed in each corner of the dissecting tray. Weezie was placed near each substance again to be observed.
In order to clean this I would collect cleaning equipment from the cleaner’s cupboard and spray the bath with appropriate cleaning agents and using a clean cloth and after cleaning the bath I would rinse this thoroughly with hot water to remove any residue from the bath. I would then proceed to mop the floor and apply a wet floor sign so to make the next user aware the floor may be wet. 2. Describe the roles and
The third step is to clean the knife using the napkin and wipe it clean. The knife is sharp so be extra careful when cleaning it to avoid injury. The fourth step is to get the jar of Jelly and the knife. Open the jar of jelly. Use the knife to scoop out a small amount of jelly from the jar.
Stop two inches from the brim to allow for stirring the water and adding ingredients without overflowing. With one hand, grab the top of the Kool-Aid package and give it a gentle shake to move all of the powder to the bottom. Keeping your hand on the top of the package and grabbing the rest of the package with your other hand, slowly pull with the hand on top to tear about a centimeter off the package. Pour the contents of the package in the pitcher of water. Using the measuring cup, add two cup of confectioner’s sugar into the pitcher as well.
Use your 4 markers to draw a different colored dot on each of the pencil marks on the paper strip. Allow the markers ink to dry, and then go back recolor each dot. 5. Prepare the saltwater mixture by mixing 1/8 teaspoon of salt and three cups of water in a clean 2-liter bottle. Stir or shake the solution until it is dissolved.
| | | | | | |Washing a contaminated scope. (Gastro |Once a contaminated scope has been used and then come through into the dirty side off scope | |scope/Colon scope) |wash, I first fill my sinks with water and put one squirt off disinfectant which is Thermoton| | |into the dirty side off the sinks. | | |I then put on my PPE which includes | | |Red apron
4. The outside of the flask was dried with a paper towel. 5. The stopper was firmly put in the flask. 6.
4. Record the pH measurements in your table. 5. Rinse the beaker thoroughly, and pour into it another 25ml of tap water, and add 0.1M NaOH drop by drop, recording the pH changes in exactly the same way as for the 0.1M HCl. 6.
Pour all the filtrate and washings into a 250cm3 volumetric flask. Make up to 250cm3 with 1.0mol dm-3 sulphuric acid(VI) acid. Stopper the flask and invert several times to thoroughly mix the solution. 5. Fill the burette with 0.005mol dm-3 potassium manganate(VII) solution.