1213 Essay

1488 Words6 Pages
Process Instruction DOC1059 Title Passenger Side Lower Door Latch Assembly Retrofit Assembly Area Field Model Honda Odyssey Engineer Rex V. Taylor Station # N/A This document describes the replacement of the Honda Passenger Side Lower Door Latch Assembly with an updated assembly. Please read and understand the following procedure before performing an actual retrofit. If you have any questions, please call VMI Tech Support. PROCESS 1. Obtain VMI retrofit kit, P/N CA3037. 2. Turn off door switch on dash. File Name DOC1059 Area Field Revision A Station # N/A Release Date March 26, 2007 Contact Ext. Rex V. Taylor 5840 Page 1 of 16 3. Remove VMI lower sliding door plastic panel. 4. To remove panel shown above carefully cut or “pop out” the retaining clips found at the front, rear and inside bottom of the panel. May vary from five (5) to seven (7) clips. Retainer Clip Retainer Clips File Name DOC1059 Area Field Revision A Station # N/A Release Date March 26, 2007 Contact Ext. Rex V. Taylor 5840 Page 2 of 16 4. Continued Two Clips Retainer Retainer Clip 5. Remove tailgate plastic lining assembly. File Name DOC1059 Area Field Revision A Station # N/A Release Date March 26, 2007 Contact Ext. Rex V. Taylor 5840 Page 3 of 16 6. Disconnect “C” pillar seat belt, remove “C” pillar upper plastic panel, and loosen right rear plastic side lining panel. Disconnect “C” pillar door switch harness and remove side lining panel from van. C Pillar Upper Panel Side Lining Panel C Pillar Seat Belt 7. Remove nut from SCHLEP mounting block and lift mounting block off stud. Move SCHLEP harness out of the way of the Inboard Shoulder Bolt. Inboard Shoulder Bolt SCHLEP Mounting Block File Name DOC1059 Area Field Revision A Station # N/A Release Date March 26, 2007 Contact Ext. Rex V.

More about 1213 Essay

Open Document