Lydell Smith NT1310 Unit4 assignment 1 copper vs. fiber In this paper I will discussed two different cabling copper and fiber cabling. I will contrast both cabling types show strengths and there weaknesses, also what situations you would choose one over the other. Copper and fiber optic wiring are the two most common and widely used cabling types today for the means of communication all over the world. Both have the same basic concept to transmit information from point A to point B but both have their strengths and weaknesses and therefore, a person installing cabling may be reluctant to choose one over the other. Copper cabling is the less expensive of the two to install.
If their expectations were not met then Greg Allen Construction Corp. could be held accountable. However, in order for Daniel and Sondra to obtain credit there were required inspections throughout the project. If throughout the process much of Allen’s work was unacceptable then the Estelle’s did what they were supposed to be. If the work was completed and no complaints were made during the inspections until after the work was completed then Allen’s corporation wouldn’t be held liable. That would be due to that the fact that the inspections were to have been assumed to be passed during the work.
In many physicians’ offices now days, it is common to find compliance codes on the physical form that is filled out by the physician. This process only helps to make sure that as few mistakes as possible are made in the coding and billing process. One of the most important factors in the coding process is accurately matching diagnoses and procedures, in order to avoid any possibilities of a claim being rejected. This is also important in the assurance of reimbursement to a medical professional for correct procedures. If an incorrect procedure is sent for billing, the result could be a physician being delayed a payment, or, missing out on payment altogether.
A signal from the source travels in both directions to all machines connected on the bus cable until it finds the intended recipient. If the machine address does not match the intended address for the data, the machine ignores the data. Alternatively, if the data matches the machine address, the data is accepted. Since the bus topology consists of only one wire, it is rather inexpensive to implement when compared to other topologies. However, the low cost of implementing the technology is offset by the high cost of managing the network.
I have worked hard to build a trustworthy reputation to safely operate a reactor and perform maintenance, and I also understand that it only takes me making one poor decision to destroy the admiration for my integrity that I have worked so hard to gain. It was once said by the founding father of nuclear power, Admiral Hyman Rickover, “I believe it is the duty of each of us to act as if the fate of the world depended on him. Admittedly, one man by himself cannot do the job. However, one man can make a difference... We must live for the future of the human race, and not for our own comfort or success.”(Rockwell, 1992) I could not agree more with this quote. Ultimately, everyone must work together and perform to the standard that has been set for us.
Copper wiring is flexible when installing so incase a technician has to bend it around a wall or at a certain angle to reach it to an end point, the cable can handle it. Also equipment to support copper wiring is relatively inexpensive to run. The weaknesses to copper wiring would be that it is susceptible to electromagnetic inference (EMI) from outside forces and also has a higher rate of corrosion over time by oxidation. Fiber optic cabling is a more expensive option for communications. Fiber optic cabling is immune to EMI and other noise interferences and therefore the chance of signal loss is greatly reduced.
writing or drawing picture to get your message across. Professional and personal skills are a number of skills you may have as an individual all learn through your career. • Punctuality/timekeeping is important to uniformed public services because being on time and not being late sets a good example for you by other staff members and also means you will have extra time in your career for unforeseen circumstance. Punctuality is a basic skill you are expected to have when you join a uniformed public service and also if your life was ever at stake or the life of others. • Pride of appearance is a very important skill when joining a public service because you want to make a good first impression to the public and this can be by polishing your shoes on a day to day basis and making sure your uniform is clean and ironed properly, cleanliness is also important so washing your hair, having a shower or a bath and also a shave.
That is why TSA setup new technology at the checkpoint. This would be better safe and everyone would not get hurt. Addition, new technology would make less crime and bomb too. In final analysis, author states passengers were still complaining about new technology. Addition, author shows that people were complain about taking off of their shoes, buckles, and coats.
So tracking him down won’t be a problem. The location will be one of the biggest hindrances for both you and the mechanic. In addition to doing the car repairs, there are other projects that will take up this mechanic’s time. The “honey do list” will take first priority. Therefore, your vehicle could be there longer than expected.
Never discriminate against anyone because of their beliefs or use offensive language with anyone. Be aware of a person’s disability, and appreciate that they will move much slower than others and also make sure that walkways are clear or them to get through Describe how to treat other people in a way that respects their abilities, background, values, customs & beliefs The best way for this is to learn to be tolerant and open minded as there is not always only one way of doing things so other peoples’ ideas are valid and valuable. Most people can be uncomfortable about other cultures or beliefs because they are not familiar with them and we can be nervous about dealing with something that we know nothing about. Most people from different cultures enjoy talking about their backgrounds and their different ways of working, however, I feel that being open minded is the best policy. Describe ways in which it is possible to learn from others at work Communicate with people regularly Listen to what other people have to say Work with other people as part of a team Ask people for information Don’t be afraid to ask for help and be interested in how other