To do this, first take the number of drops used to achieve the monolayer (1 drop) and convert it to mL using the calibrated number of drops per mL. Then multiply the number of grams of sodium stearate per milliliter of solution. Finally, convert to moles through the molar mass of sodium stearate. HINT: The molar mass of sodium stearate is 296.5 g/mole. Answer = 1.06*10^7 moles/top layer 5.
12. Place a paper towel over the drain, pour the content of the well plate, throw the paper towel and rinse the well plate. DATA, OBSERVATIONS, AND CALCULATIONS: Data Table: Oxidation - Reduction | | Reactions | Mg in Na2SO4 | Bubbles | Zn in MgSO4 | Small bubbles | Pb in Zn(NO3)2 | Dark lead changed into lighter color | Pb in FeCl3 | Changed the lead into slight green yellow | Fe in CuSO4 | Changed the iron into orange color | Note: I added more than 10 drops to make sure that the pieces are well covered. QUESTIONS: A. Based on your observations make an activity series of the metals used.
Digestive enzymes are hydrolytic enzymes. Their substances, or the molecules on which they act are organic food molecules which they breakdown by adding water to the molecular bonds, thus cleaving the bonds between the subunits or monomers. Digestive enzymes can function outside the body cells; their activity can be studied by test tubes (Marieb and Mitchell 2010). This experiment attempts to re-create the breakdown process that is normally done via digestion with Iodine as a vital component. It can be expected that once amylase reacts with the starch, maltose will then be broken down and less starch will be visible and more sugar will be apparent thus causing the solution mixed with iodine to become lighter and lighter.
Title: 1pt Stoichiometry Of A Precipitation Reaction 2. Procedure: 2pt (Write the procedure in your own words after you have read the lab manual) Put on goggles the weigh 1.0 of CaCl*2H2O and put it in 100ml beaker. Add 25 mil of water and stir. I will then use stoichmetry to figure out how much Na2CO3 I will need for a full reaction. I will weigh this and put it in a separate cup.
Once the buffer tablet has dissolved into the water, add 10 ml of starch solution. 3. After the starch solution has been added, add 10 ml of enzyme solution to the current solution, simultaneously start the timer and record at 1 minute intervals. 4. In addition, place iodine in the dropping tile in order to identify if starch is currently present.
Hypothesis : When the quails’ eggs are immersed into 0% (distilled water), 5%, and 15% concentration of sodium chloride solution, the final mass of the quails’ eggs will increase. But when the quails’ eggs are immersed into 30% and 45% concentration of sodium chloride solution, the final mass of the quails eggs will decrease. http://www.biologyjunction.com/osmosis_lab_report_sample_4_prea.htm ,visited on 30/8/2012
(Swann, 2008) The pancreas also makes amylase (alpha amylase) to hydrolyse dietary starch into disaccharides and which are converted by other enzymes to glucose to supply the body with energy. Hypothesis: Most enzymes are very specific for a certain substrate. The active site on the enzyme molecule forms a keyhole into which the substrate fits like a key. The substrate molecule is then broken up into many smaller pieces. “The higher the reaction temperature, the more kinetic
Adjust the percent transmittance to 100% 4)our out the water in the cuvet, and fill with 2/3 of the reference solution. Read and record absorbance data. Read from lower concentration to higher concentration. 5)Continue to collect absorbance data for al reference and test solutions 6)Dispose of the contents of the cuvets. Data Tables #1 Reference Solutions for the Calibration Curve Sample [FeSCN2+] Absorbance Reference Solution #1 4x10-5 .2034 Reference Solution #2 6x10-5 .3028 Reference Solution #3 8x10-5 .3915 Reference Solution #4 1.0x10-4 .4908 Reference Solution #5 1.2x10-4 .5768 #2 Test Solutions Temperature - 21.9°C Sample [Fe3+] [SCN-] Absorbance Test Solution #6 1.0x10-3 2.0x10-4 .1002 Test
Enzyme Activity Lab By: Cheyenne Sherrill Lab partners: Brandon, Sade, and Jason Due date: November 27th 2012 Mr. Clark D1 honors Procedure: All the metabolic activity and processes within the cell require enzymes to occur. This includes synthesis and decomposition reactions. Enzymes are specialized proteins (organic catalyst) that speed up the rates of reactions that would otherwise be to slow or not able to occur at all in the cell. 1) Sand and peroxide- a pinch of sand and 2ml of hydrogen peroxide in a standardized test tube. Measure the height of the reaction with a ruler in millimeters.
They were glucose, water, lemon juice, Coca Cola, egg batter, lemon-lime soda, diet lemon-lime soda, Kraft Italian dressing, skim milk and butter. The positive control was the glucose and the negative control was the water. Twenty drops of each sample of substance was added to the test tubes (in all there were 10 test tubes). After the solutions were added in their own test tube, 20 drops of Benedict’s reagent was added. Each individual test tube was placed in boiling water and removed after 5 minutes to test if