Explain the effect that the flow tube radius change had on flow rate. How well did the results compare with your prediction? The increase of flow tube radius increased the flow rate, as predicted. 3. Describe the effect that radius changes have on the laminar flow of a fluid.
Any increase in the rate of reaction will cause an increase in the pressure of the oxygen. The first line of the graph (top) represents the normal rate of the reaction in a water solution of hydrogen peroxide and catalase. The second line represents the rate of reaction when acid is added to the solution and the third line represents the rate of reaction when a base is added to the solution. 1. What variable is plotted on the x-axis?
The force of the isometric contraction increased as the muscle load increased. 9. Which would be a better predictor of increase in force of contraction, change in sEMG amplitude of spikes or change in sEMG frequency of spikes? Change in sEMG frequency of spikes. Discussion 1.
Different types of rocks are created based on the amount of pressure. The higher the pressure, the more drastic the change. The temperature increases the deeper a rock is. This gives good possibilities for more diverse changes. Examples of regional metamorphic rocks include schist and gneiss.
The change in enthalpy relies on the concentration of the salt solution, because different concentrations will produce different enthalpies. There is an equation to determine how much of this heat energy is lost or gained when a reaction is performed. Q = c m (T1-T2) Where: q is the energy in Joules C is the heat capacity, measured in joules per gram per degree Celsius M is the mass of the solution, measured in grams J is the joules G is the grams of water T is the temperature ΔH=ΔE + PΔV = (q p +w) – w = q p Procedure: 1. Follow instructions 1-9 in Appendix A-1 to initialize the MeasureNet workstation. a.
Electrons can now continue to move through PSII and the cytochrome b6 f complex, and oxygen is produced in the water-splitting reaction. 34. Bioenergetics of Photophosphorylation The steady-state concentrations of ATP, ADP, and Pi in isolated spinach chloroplasts under full illumination at pH 7.0 are 120.0, 6.0, and 700.0 mM, respectively. (a) What is the free-energy requirement for the synthesis of 1 mol of ATP under these conditions? (b) The energy for ATP synthesis is furnished by light-induced electron transfer in the chloroplasts.
As you move from the first period, to the second and so on, elements gain electron shells. Because of the added shell, the atomic radius increases. Therefore as you move down a group, the atomic radius increases. As you move to the right of a period, electrons are gained. The shell number stays the same,
Hypothesis With increasing temperature of sodium thiosulphate the reaction rate will increase as well. Justification As the collision theory states for a chemical reaction to occur particles need to collide at a certain speed and angle. Increasing the temperature gives particles more energy, so they move faster. As they move faster more collisions happen, hence more successful collision, which increases the rate of the reaction1. Materials> Hydrochloric acid HCl(l)> Sodium triosulphate Na2S2O3(l)> 250 ml3 beaker> 50 ml3 conical flask> 2 x 25 ml3 measuring cylinder> Thermometer> Stop clock> Tea kettle> Blank card> Pen Variables Reaction time is the dependent variable, as it depends on the temperature of the solution.
These two components are naturally occurring from sources like volcanoes but the industrial revolution has exponentially increased the amount of these chemicals in the air. The two components adjust the pH levels of water bring them down to sometimes sever acidic levels. pH levels are measured on a scale from 1-14. A pH level of 7 is a neutral water level; higher levels are alkaline and lower are acidic. Normal rainwater can sometimes be as low as a pH level of 5.0.
Expansion, an increase in the volume of a substance, usually due to the addition of heat to the substance. The heat causes the molecules of the substance to move farther apart, making the substance occupy more space. A loss of heat causes the opposite effect, known as contraction. Although most substances expand when heated, not all expand at the same rate. Aluminum, for example, expands twice as much as iron when both are heated the same amount.