In part one of the lab we used a micro scale technique to derive an activity series for metals. With the use of this technique we measured the same amount of different metal nitrate solutions into each well. Then we placed a piece of metal in the other metal nitrate solutions. With the data we recorded we resulted our activity series for the metals. We resulted that lead, silver, and copper are the strongest oxidizing agents, and that magnesium and zinc are the weak oxidizing agents.
Focus Question Should chemists prepare Zinc Iodide, from its elements or from a Double Replacement Reaction between Barium Iodide and Zinc Sulfate? -To put things into perspective in terms of cost efficiency, zinc granules cost about $62.50 per kilogram or $.0625 per gram. Also, Iodine chips cost about $.1498, Barium Iodide Dihydrate costs about $.886 per gram, and Zinc Sulfate Heptahydrate costs about $.0405 per gram. According the chemical reaction listed below, the double replacement reaction creates a solid Barium Sulfate precipitate This means that the ZnI2 is less pure than it would be from just the Zinc and the Iodine. With the elemental reaction you get ZnI2 as your only product thus indicated that it is “pure” Zinc Iodide.
How many moles of zinc are in a penny? Purpose: this lab is being performed so students can visualize a single-replacement reaction and calculate how much zinc is in a post-1982 penny? Materials: A post- 1982 penny steel wool 3 M HCl graduated cylinder Small beaker tongs Balance paper towels Sharp edge Safety: 3 M hydrochloric acid (HCl) is fairly caustic. Wash hands immediately is you spill on them. Wear goggles.
2) Define weighted average- An average that takes into account the proportional relevance of each component, rather than treating each component equally. 3) Place one atom of each isotope on the scale. Divide the mass by 3 to fine the straight average. How is this number different from your average atomic mass? Number – 19g average mass 1.7g 4) If a 4th isotope of beanium, D (green), were added to the pool, how would the average atomic mass change?
o D. The mass is not exactly 255.0 grams, but it is impossible to tell whether the mass is greater than or less than 255.0 grams. 5. 5. You place a mass of 250 grams on the measurement tray of a triple beam balance and then set the rider on the 500 gram beam to the 200 gram mark (the other riders are set to 0 grams). Which of the following statements is true?
The absorption spectrum is measured using a spectrophotometer and the data is graphed in Excel. The peak of the line is used to find Vmax of Fe2+. Vmax is used to find the moles of Fe2+ and ligand. The unknown n is a ratio of moles ligand divided by moles Fe2+. Results and Discussion For the first part of the experiment (Part A), five different 100 mL volumetric flasks were each filled with 1,2,3,4 and 5 mL of iron (II) solution.
0.00079 moles EDTA4- c. 0.00079 moles ZnI2 d. 0.0517 grams of ZnI2 are in the sample e. 0.0517/0.237= 21.8% f. Error Is 6.34% Lab Report: Part 1: In this lab we used the following supplies: * Zinc Iodide * Na2H2EDTA(s) * Calmagite indicator solution * pH 10 buffer solution * 6M Acetic Acid * Unknown Zinc Compound The main purpose for this part of the lab was to determine the amount of zinc ion in a sample of ZnI2 by titration. The two types of zinc: * Zinc iodide made by zinc and iodine * Commercially purchased zinc iodide (the
Part B: The graduated pipet’s average density at 22.3 °C was determined to be 0.9785g/mL with a percentage error of 1.89% shows the graduated pipet to be more accurate and precise. Part C: Density of an unknown NaCl solution was measured and a calibration curve used to determine the percentage of NaCl by mass in the solution. y=0.007x + 0.998 which concluded that the concentration of the sodium chloride solution was 3.14%. INTRODUCTION Anything that you can see, touch, taste or smell, occupies space and has mass, it is called matter. Matter can be a gas, a liquid,
Introduction: Thyme contains a surprising amount of iron compounds. This experiment enables us to determine the amount of iron(II) present in dried thyme by means of a redox reaction. Method: 1. Weigh accurately about 1g of dried thyme and put into a 250cm3 beaker. Record the mass of thyme used.
Lab #09: Is the Substance Ionic or Covalent? Purpose: To identify compounds as ionic or covalent based on their properties. We will do this by testing melting point, conductivity, and solubility. Hypothesis: Draw a chart in which you will predict what your results will look like for the three different tests for an ionic compound and a covalent compound. We will fill this table in