Ac2351 Unit 1

EC2351 MEASUREMENTS AND INSTRUMENTATION L T P C

3 0 0 3

UNIT I BASIC MEASUREMENT CONCEPTS

Measurement systems – Static and dynamic characteristics – units and standards of

measurements – error :- accuracy and precision, types, statistical analysis – moving coil,

moving iron meters – multimeters – Bridge measurements : – Maxwell, Hay, Schering,

Anderson and Wien bridge.

UNIT II BASIC ELECTRONIC MEASUREMENTS

Electronic multimeters – Cathode ray oscilloscopes – block schematic – applications –

special oscilloscopes :– delayed time base oscilloscopes, analog and digital storage

oscilloscope, sampling oscilloscope – Q meters – Vector meters – RF voltage and

power measurements – True RMS meters.

UNIT III SIGNAL…show more content…
UNIT II BIO-CHEMICAL AND NON ELECTRICAL PARAMETER
MEASUREMENT

PH, PO2, PCO2, PHCO3, Electrophoresis, colorimeter, photometer, Auto analyzer,
Blood flow meter, cardiac output, respiratory measurement, Blood pressure, temperature, pulse, Blood cell counters.

UNIT III ASSIST DEVICES AND BIO-TELEMETRY

Cardiac pacemakers, DC Defibrillator, Telemetry principles, frequency selection, Biotelemetry, radio-pill and tele-stimulation.

UNIT IV RADIOLOGICAL EQUIPMENTS

Ionosing radiation, Diagnostic x-ray equipments, use of Radio Isotope in diagnosis,
Radiation Therapy.

UNIT V RECENT TRENDS IN MEDICAL INSTRUMENTATION

Thermograph, endoscopy unit, Laser in medicine, Diathermy units, Electrical safety in medical equipment.
TOTAL : 45 PERIODS
TEXT BOOK
1. Leislie Cromwell, “Biomedical instrumentation and measurement”, Prentice Hall of
India, New Delhi, 2007.
REFERENCES
1. Khandpur, R.S., “Handbook of Biomedical Instrumentation”, TATA McGraw-Hill,…show more content…
2. Design Entry and simulation of sequential logic circuits (counters, PRBS generators,

accumulators). Test bench creation, functional verification, and concepts of

concurrent and sequential execution to be highlighted.

3. Synthesis, P&R and Post P&R simulation for all the blocks/codes developed in Expt.

No. 1 and No. 2 given above. Concepts of FPGA floor plan, critical path, design gate

count, I/O configuration and pin assignment to be taught in this experiment.

4. Generation of configuration/fuse files for all the blocks/codes developed as part of

Expt.1. and Expt. 2. FPGA devices must be configured and hardware tested for the

blocks/codes developed as part of Expt. 1. and Expt. 2. The correctness of the

inputs and outputs for each of the blocks must be demonstrated atleast on

oscilloscopes (logic analyzer preferred).

5. Schematic Entry and SPICE simulation of MOS differential amplifier. Determination

of gain, bandwidth, output impedance and CMRR.

6. Layout of a simple CMOS inverter, parasitic extraction and simulation.

7. Design of a 10 bit number controlled oscillator using standard cell